HOW TO SHORTEN A ZIPPER*

1. Determine the final length you want the zipper to be. At the top end of the zipper, mark this measurement using chalk, or mark the point with a safety pin.
2. Select two new stops for the endpoint. The gauge of the stops should be the same or less than the gauge of the zipper teeth. For example, for a #5 nylon coil zipper, you can use #3 stops
3. Using needle-nose pliers, take the first bottom stop (bottom stops are used as top stops on nylon coil zippers) and pierce the zipper tape with the stop’s prongs and fold the prongs down so they are nestled between the teeth. You don’t want any points sticking out where they can scratch the person wearing the garment. Use the pliers to flatten the prongs, creating a new stopping point.
4. Leave 1-2” of lead tape above the new stops, and cut off any excess zipper tape.

1. Determine the final length you want the zipper to be. At the top end of the zipper, place a mark at this measurement using chalk, or mark the point with a safety pin.
2. Select two new stops for the endpoint. The gauge of the stops should be the same gauge of the zipper teeth. For example, for a #5 brass tooth zipper, you should use #5 brass top stops. In a pinch, the stops could also be slightly larger. The metal finish of the stops should also ideally match the finish of the zipper teeth. e.g. gold stops with brass tooth zipper, silver stops with nickel tooth zipper.
3. Using a zipper shortening tool, pull out the first zipper tooth. This is the tooth that is aligned with the end-point marking.
4. Going up the same side of the zipper, pull the next ~1.5” to 2” of zipper teeth out above the initial tooth that you pulled. About 2” of zipper tape should be cleared.
5. Do the same thing on the other side of the zipper. Due to the two sides of the zipper teeth being offset from one another, one side of teeth will be slightly higher than the other.
6. With pliers, clamp on the new top stops. Adjust them so that they are even with each other.
7. With pinking shears or a sharp pair of fabric scissors, cut off the excess zipper tape, about 1.5” – 2” above the new top stops. Viola! You have a shorter zipper!

The method is similar to shortening metal-tooth zipper. However, some molded plastic zipper teeth don’t pull off in a single try. Instead, you might have to chip away at the tooth and peel any stubborn pieces off the zipper tape.

As far as which top stops to use for molded plastic zippers, use stops of a comparable gauge and with the look that you prefer. Unless the zipper is black, it is unlikely that you will have stops that match exactly. A neutral metal stop like silver often works best.

Shortening zippers is a useful tool in your sewing toolkit. If, however, you just want to get the job done without the fuss, you can leave it to the pros and use Zipper Shipper's shortening service!